Adjusting The Base Level Angle - HOLZMANN MASCHINEN TK305 Manual De Intrucciones

17.4.3 Adjusting the base level angle

1. Hold the "circular pan lock knob" and loosen it. Then
trigger the spring pin always.
2. Put the board on the "circular pan" ;
3. Reference "location ruler" to select a cutting length, then
screw up the "clamp groupware" knob until it to clamp the
board
4. Rotate and locate the "circular pan" by "circular pan lock
knob.
5. According to your actual required of cutting angle to
select and locate it.
Remark: The "circular pan" rotate angle are between to left /
right sides of 45°~0° ~ -45°.
6. Press the "cutting head".
7. Cutting the board until it to separate
8. Loosen the trigger of the mitre, until it slowly to rise.
9. Release your hand.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
OPERATION
39
TK 305