Tabla De Contenido; Operator Safety Instructions - Amano American Sanders American 12 Manual Del Operador

EN
This book has important information for the use and safe operation of this machine. Failure to read this book prior to operating
or attempting any service or maintenance procedure to your American Sanders machine could result in injury to you or to other
personnel; damage to the machine or to other property could occur as well. You must have training in the operation of this machine
before using it. If your operator(s) cannot read this manual, have it explained fully before attempting to operate this machine.
All directions given in this book are as seen from the operator's position at the rear of the machine.
Contents
Operator Safety Instructions ............................... 2
Introduction and Machine Specifications ............ 6
230V Electrical Connection Instructions ............. 7
How to Transport the Machine............................ 8
Machine Set-Up ..................................................9
How to Operate the Machine ............................ 10
Sanding Cuts and Sandpaper .......................... 13
Sander Adjustment Procedures ........................ 13
Routine Maintenance........................................15
Troubleshooting ................................................16
Chatter-Wave Prevention ................................. 17
WARNING!
The Products sold with this Manual contain or may contain chemicals that are known to certain governments (such as the State of
California, as identified in its Proposition 65 Regulatory Warning Law) to cause cancer, birth defects or other reproductive harm. In
certain locations (including the State of California) purchasers of these Products that place them in service at an employment job site
or a publicly accessible space are required by regulation to make certain notices, warnings or disclosures regarding the chemicals that
are or may be contained in the Products at or about such work sites. It is the purchaser's responsibility to know the content of, and
to comply with, any laws and regulations relating to the use of these Products in such environments. The Manufacturer disclaims any
responsibility to advise purchasers of any specific requirements that may be applicable to the use of the Products in such environments.
In this Operation Manual you will find three statements that you must read and observe to ensure safe operation of this
machine.
DANGER means: Severe bodily injury or death can occur to you or other personnel if the DANGER statements
found on this machine or in this Operation Manual are ignored or are not adhered to. Read and observe
all DANGER statements found in this Operation Manual and on your machine.
WARNING means: Injury can occur to you or to other personnel if the WARNING statements found on your
machine or in the Operation Manual are ignored or are not adhered to. Read and observe all WARNING
statements found in this Operation Manual and on your machine.
CAUTION means: Damage can occur to the machine or to other property if the CAUTION statements found
on your machine or in this Operation Manual are ignored or are not adhered to. Read and observe all
CAUTION statements found in this Operation Manual and on your machine.
READ THIS BOOK
SECTION II - Parts and Service Manual
Handle Assy (Models 07108A, 07109A, 07204A, 07108C) .................. 36
Handle Assy (Model 07001A, 07108B)................................................. 38
Handle Assy (Model 07120A). .............................................................. 40
Motor Assy (Model 07001A, 07108B). .................................................. 42
Motor Assy (Models 07108A, 07109A, 07204A, 07108C) .................... 43
Motor Assy (Model 07120A) ................................................................. 44
Drum Assy ............................................................................................ 45
Dust Control Assy ................................................................................. 46
Base Assy ............................................................................................. 48
Base Assy (Models 07044C, 07049C).................................................. 50
Belt Guard Assy (Models 07108A, 07109A, 07204A, 07108C) ............ 52
Belt Guard (Model 07001A, 07108B) ................................................... 53
Belt Guard (Model 07120A) .................................................................. 54
Accessories .......................................................................................... 55
Wiring Diagrams ................................................................................... 56
Warranty ............................................................................................... 58
***This product is intended for commercial use only***

Operator Safety Instructions

2