Electrical Connection Instructions - Amano American Sanders American 12 Manual Del Operador

EN
CAUTION:
This machine will operate only on AC fre-
quency and on electrical voltage shown on
the equipment nameplate. Make sure you
have the correct frequency and voltage before
connecting the power cord to an outlet. See
the example in figure 1.
This machine must be connected to an electrical source with an
earthing conductor in order to protect the operator from electric
shock. This machine has an approved power cord with three
conductors as well as a plug with three terminals. Connect the
plug to a matching receptacle.
DANGER:
Electrocution could occur if the machine is
exposed to water or rain. Keep the machine
in a dry building.
DANGER:
Electrocution could occur if machine is not
connected to an electrical source with an
earthing conductor. To prevent possible
electric shock, use an electrical cord with an
earthing conductor and connect it to a match-
ing electrical source. For maximum protection
against electrical shock, use a circuit that is
protected by a ground fault circuit interrupter.
Consult your electrical contractor.
DANGER:
Electrocution could occur if the machine is
used with a damaged plug or power cord. If
the cords or plugs are worn or damaged in
any way, have them replaced by an authorized
service person or electrician.
Extension Cords
Use only an approved three-pronged extension cord with two main
conductors and one earthing conductor. This machine is equipped
with a power cord. When greater range is needed follow the table
below to determine cable gauge of additional footage. Refer to
the chart to the right for extension cord information.
If motor appears to labor or takes a considerable longer time to
come up to speed reduce sanding pressure.

Electrical Connection Instructions

Feet/Wire Guage (Stranded Copper)
Source Voltage
208
230
7
Figure 1
0 - 100' 100 - 250'
Use Voltage
6
Booster
10 8