en
CAUTION
Electrical defect!
Condensate that accumulates in the motor can cause an electrical defect.
• Insulate the pump housing only up to the separating gap to the motor!
• Keep the condensate drain grooves unobstructed to ensure that condensate that develops
in the motor can drain off unobstructed! (Fig. IX)
7
Electrical connection
Electrical connection may only be carried out by a qualified electrician and in accordance with the applicable
regulations!
Safety-relevant information from other chapters must be strictly observed!
DANGER
Risk of fatal electrical shock!
Immediate risk of fatal injury if live components are touched!
In particular, persons with medical aids, such as cardiac pacemakers, insulin pumps, hearing
aids, implants or similar are at risk.
Death, severe injury and damage to property may be the result.
A professional medical assessment is always necessary for such persons!
Applying an incorrect voltage to SELV lines will result in incorrect voltage in all pumps and on-
site building automation devices that are connected to SELV lines.
• Before commencing work, switch off the power supply and secure it from being switched
on again.
– Due to the presence of dangerous contact voltage, work on the control module must
not be started until 5 minutes have elapsed!
• Check whether all connections (including potential-free contacts) are voltage-free.
• Only connect or operate the pump with the control module installed.
• Never open the control module and never remove configuration and operating elements.
• Never put the pump into operation if the control module/Wilo plug is damaged.
• Never apply incorrect voltage.
7.1
Requirements
NOTICE
Nationally applicable guidelines, standards and regulations as well as the requirements of local
energy supply companies must be observed!
CAUTION
Incorrect connection
Incorrect connection of the pump results in damage to the electronics.
54
Installation and operating instructions • Wilo-Yonos MAXO/-D/-Z • Ed.01/2022-08