Anomalies - Causes - Remedies - Fiorenzato F64 E Manual De Instalación, Uso Y Mantenimiento

EN
7

ANOMALIES - CAUSES - REMEDIES

The table shows possible faults that may cause the grinder-doser not to work and/or not
to function properly. For each anomaly, the possible cause is indicated along with the
actions to be taken to restore the correct operation of the appliance.
Anomaly Cause
The grinder-doser No power supply.
does not switch on.
The coffee beans Locking slide closed.
do not fall out of the
supply hopper.
The system loses The backup battery
data from previous of the machine
settings when it is management system
switched on. is fl at.
The grinding blades
The icon ' '
are close to the
appears on
manufacturer's working
the display
hour limit and therefore
accompanied by
their replacement must
an alert message
be planned.
about the need to
replace the grinding
blades.
40 / 44 EN
ON DEMAND line
Remedy
• Make sure that the switch is in
the 'I' (ON) position;
• Make sure that the
thermal-magnetic circuit
breaker upstream of the socket
(if present) is in the 'ON'
position.
• Ensure that the power cable is
intact and correctly connected
to the electrical socket provided
at the location of use.
• Open the locking slide.
• Contact the service department
to replace the backup battery.
• The grinder-doser can be
used until the set time limit is
reached. When the time limit
has been reached, the grinding
blades must be replaced in
order to guarantee maximum
machine effi ciency, following the
instructions given in paragraph
6.1.5.
• Once they have been replaced,
the specialist technician resets
the time counter for the grinding
blades.
Fiorenzato | ON DEMAND_00 line Ed. 03/2022
ON DEMAND line
Anomaly Cause
During grinding the Triggering of the motor
motor stops. thermal-magnetic circuit
breaker due to blockage
of the grinding system
if objects or foreign
bodies are between the
grinding blades.
ATTENTION! If the anomaly persists even after carrying out the
recommended corrective actions, or if functional anomalies occur that
are not indicated in the table, contact your local dealer, who will decide
whether to contact the Fiorenzato M.C. S.r.l. service department or have
the appliance repaired or overhauled by a specialised technician.
Fiorenzato | ON DEMAND_00 line Ed. 03/2022
EN
Remedy
• Switch off the appliance and
wait until it has cooled down
completely.
• Disconnect the appliance from
the mains power supply.
• Close the locking slide and
remove the supply hopper.
• Clean the grinding chamber and
remove any foreign bodies.
• Reassemble the appliance and
start a grinding cycle.
41 / 44 EN