Descargar Imprimir esta página

Acqua Brevetti PuliMATIC FT366 Instrucciones De Instalacion Y Uso página 31

Ocultar thumbs Ver también para PuliMATIC FT366:

Publicidad

Idiomas disponibles

Idiomas disponibles

A1.4 Dealers and Technical Service Centers (TSC) authorized by
Acqua Brevetti Srl
The device servicing must be performed only by technical service centres authorized by
Acqua Brevetti SRL. To get any information about retailers and authorized service centres please
contact Acqua Brevetti SRL (phone +39.049.8974006, email: servizi@acquabrevetti.it).).
A1.5 PuliMATIC operation
PuliMATIC filters the water from the outside to the inside of the filter cartridge.
PuliMATIC is a self-cleaning filter equipped with electronic management that starts the filter
cartridge washing and the discharge of impurities from the vessel completely automatically.
Thanks to its patented brushing and drainage system, the equipment guarantees an effective
cleaning of the filtering cartridge. The washing cycle involves the complete brushing of the
cartridge.
The automatic opening of the drain valve (located on the bottom of the vessel) creates a high-
speed tangential flow that removes impurities accumulated in the filter vessel.
PuliMATIC is equipped with two voltage-free contacts, which are activated according to an
advance preset by the program with respect to the washing cycle start. This signal advanced with
respect to the washing cycle can be used for managing auxiliary equipment (e.g. solenoid valves,
pumps, pressure differential switch, alarms, etc.). In the event of a power failure, the filter retains
the last programmed setting when it is switched on again.
The consumption of water for a wash is of about 14 liters (referred to a 6 bar pressure).
A1.6 PuliMATIC filter performance and technical data
PuliMATIC
Fittings
Flow Rate (ΔP=0,2 bar)
Flow Rate (ΔP=0,5 bar)
Filtration degree
Min/max operating pressure
Nominal pressure (PN)
Min downstream pressure
Water consumption
Min/max water temperature
Min./max.
temperature
Power supply
Protection degree
Drain size
The use of the equipment outside of the above and according to different characteristics than those reported is to be
considered improper use. Acqua Brevetti SRL cannot be held responsible for any damage caused by improper use of the
equipment or non-compliance with what is stated in this manual.
PuliMATIC - ENGLISH
Model
inch
m
/h
3
m
/h
3
micron
bar
bar
bar
l/cycle
°C
ambient
°C
V/Hz
IP
DN
MAN141 PAGE E-4
FT360
FT362
¾" F
1" F
4,8
6,0
6,4
9,6
FT366
FT364
1" ¼ F
1" ½ M
6,5
12,0
10,6
22,0
89
1,5 - 16
16
2,5
19 - 14
5 – 30
5 - 40
230/50
44
50
FT368
2" M
14,2
22,6

Publicidad

loading

Este manual también es adecuado para:

Pulimatic ft368