A3 Troubleshooting - Acqua Brevetti PuliMATIC FT366 Instrucciones De Instalacion Y Uso

1- Access the diagnostics page
2.1- Manual step mode operation of the gearmotor
2.2- Manual continuous mode operation of the gearmotor
3- Solenoid valves enabling/disabling (Optional)
3- Confirm settings
If the filter is not in the correct position when exiting the diagnostic page, the gearmotor will start to
rotate until the system reaches the original filtration position.

A3 TROUBLESHOOTING

Anomaly
Upon water delivery
request, water pressure
drops considerably
The filter does not react
when buttons are pressed
ALARM flashing message
on the display alternating
with the interior lighting
The filter keeps performing
washing procedures
Leakage of water from the
filter drain
PuliMATIC - ENGLISH
Press
Press
Press
Press
Press
Cause
Filtering element dirty
Voltage interrupted
Power supply unit defective
Electric circuit not working
The filter is out of order
If present: Differential switch
blocked
The drain valve is out of phase
MAN141 PAGE E-15
sequentially and hold the pressure for 7
seconds on the indicated buttons
repeatedly to operate the gearmotor in step
mode
hold the pressure to operate the gearmotor in
continuous mode
to activate the solenoid valve (ON) or
deactivate it (OFF)
to confirm and exit the diagnostic page
Solution
Perform a washing
Check the power supply
Replace the power supply unit
Replace the electrical circuit
Set the equipment to the by-
pass mode
Disconnect and connect again
the filter power supply in order
to reset the alarms
If necessary, contact the service
center
Contact the service center
Contact the service center