What To Do If The Descaling Procedure Is Interrupted - Gaggia Milano ANIMA Manual De Instrucciones

CALC
CLEAN
4219-465-09541 MANUAL GAG. ANIMA PLUS EN-ES-PT Rev 00.indd 23
11 The second stage of the cleaning cycle starts, that is the rinse cycle. This stage
lasts for 3 minutes. The display will show the rinse icon and the duration of this
stage.
Note: if the water tank is not filled up to CALC CLEAN level, it may be necessary to
repeat the rinse cycle.
12 Wait until the machine does not dispense water anymore. The descaling
procedure is complete when the display shows a tick.
13 Press the OK button to end the descaling procedure. The machine starts
warming up and performs an automatic rinse cycle.
14 Remove the container and empty it.
15 Insert the Classic Pannarello (depending on the model).
16 Clean the brew group as described in the "Brew Group Cleaning under Running
Water" chapter.
17 Install a new "INTENZA+" filter in the water tank.
Note: the "INTENZA+" filter reduces the frequency of the descaling.

What to do if the descaling procedure is interrupted

You can exit the descaling procedure pressing the STAND-BY button on the control
panel. In case the descaling procedure stops before its completion, perform the
following operations:
1 Empty the water tank and wash it thoroughly.
2 Fill the water tank with running water up to the CALC CLEAN level indication
and switch on the machine again. The machine will warm up and perform an
automatic rinse cycle.
3 Perform a manual rinse cycle before preparing any beverage. To perform a
manual rinse cycle, dispense half a tank of hot water, then prepare 2 cups of
pre-ground coffee without adding ground coffee.
Note: if this operation is not complete, it is necessary to perform another descaling
procedure as soon as possible.
ENGLISH
23
06/04/2022 11:13:23