Gaggia Milano ANIMA Manual De Instrucciones página 28

ENGLISH
28
Problem
The milk does not foam. The classic pannarello is dirty or
The "INTENZA+" filter
icon is shown on the
display after the filter
has been replaced.
The "INTENZA+" filter
cannot be inserted.
There is some water
under the machine.
4219-465-09541 MANUAL GAG. ANIMA PLUS EN-ES-PT Rev 00.indd 28
Cause
not assembled correctly.
The type of milk used does not
produce froth.
The steam wand nozzle is clogged.
(model with steam wand)
The RESET has not been confirmed
through the machine menu.
Remove air from the filter.
The tank still contains some water.
You have tried to install a filter other
than "INTENZA+" filter.
The rubber O-ring is not connected
to the "INTENZA+" filter.
The drip tray is too full and has
spilled over.
The machine has not been placed
on a horizontal surface.
Solution
Clean the classic pannarello and check that it
is assembled correctly.
The amount and the quality of froth vary
depending on the type of milk. We have tested
the following types of milk and obtained
satisfying results of froth: semi-skimmed or
whole cow's milk, soy milk and lactose-free
milk. We have not tested other types of milk
because they may produce a scarce amount
of froth.
Wash the steam nozzle with running water and
clean the circuit by dispensing a small quantity
of steam.
Confirm the activation of the filter using the
machine menu (see "Enabling the "INTENZA+"
filter").
Let the air bubble flow out from the filter.
Empty the water tank before installing the filter.
"INTENZA+" filter is the only one that can be
inserted into the machine.
Check the O-ring packaging and connect it to
the "INTENZA+" filter.
Empty the drip tray when the indicator appears
though the tray. Always empty the drip tray
before starting the descaling procedure.
Place the machine on a horizontal surface
so as that the "drip tray full" indicator works
correctly.
06/04/2022 11:13:26