Greenlee 881GX Cam Track Manual De Instrucciones página 11

6. Line up the cylinder block holes with the appropriate
position for the conduit size and yoke. (Fig.4) Pay
attention to the marks on the connecting forks. If
the cylinder block is in the wrong position, the ram
could over extend and cause tool damage.
• The yoke is used for 2-1/2"- 4" conduit and the
cylinder block must be located at the position
marked for the conduit size.
• The extended yoke is only used for 2-1/2"and
3" conduit and the cylinder block must be
located at the top position.
CYLINDER BLOCK &
CONDUIT
SIZE
YOKE-SHOE CONNECTIONS
2-1/2"
3"
3-1/2"
4"
Figure 4
52093598 Rev 00
Cam Track® Hydraulic Bender
7. Pin the appropriate yoke to the ram piston with the
spring clip. (Fig. 5) To bend 3-1/2" and 4" conduit
after using the extended yoke, change to the yoke
and leave the cylinder block in the top position.
8. Insert the cylinder block hitch from the side where
the cylinder block extends out past the connecting
forks.(Fig. 6)
Hitch
Pin
Head
Cylinder
Block
9. While keeping the hitch pin head tight against the
connecting fork face, insert the clip in the hole
closest to the opposite connecting fork face. Repeat
for second pin. (Fig. 7)
For
Changeover
© 2022 Greenlee Tools, Inc.
Figure 5
Hitch Pin
Clip Holes
Figure 6
26309
Forks
94848G
Forks
Figure 7
11