Assembly And Electrical Connection; Assembling The Hot And Cold Plate; Operation - Hupfer KWP Manual De Instrucciones

Operating Instructions
7

Assembly and electrical connection

EN
7.1

Assembling the hot and cold plate

CAUTION
Injuries caused by sharp edges
The mounting frame and base of the product, as well as the surface,
may have sharp edges.
►
Wear suitable protective gloves when transporting and
installing the product.
ATTENTION
Heat accumulation
If the cut-out for supply and exhaust air is blocked or is too small,
heat builds up. Heat accumulation has a negative impact on

operation.

►
Plan to ensure the cut-out is of sufficient size for the supply
and exhaust air.
►
Make sure that the cut-out for supply and exhaust air is not
blocked during operation.
The hot and cold plate is permanently installed in a counter with a
suitable substructure for support; the display is installed separately in
the same counter or the optional heated lamp gantry. The counter
must have a lockable inspection opening that allows access to the
base of the hot and cold plate and, if necessary, the power supply.
Once assembly is complete, the warning labels supplied with the
product must be affixed to the counter in a clearly visible position in the
immediate vicinity of the product.
Information on the layout of cut-outs and supports and the necessary
assembly work can be found in the separate assembly instructions.
Depending on the version with or without mounting frame, an
additional sealing of the hot and cold plate is required after assembly.
Please observe the information in the assembly instructions.
Make sure that the cut-out for supply and exhaust air is the right size
and is not blocked during operation.
Hot and cold plate
Page 15