Manual Programmes - TensCare Sure PRO Instrucciones De Uso

Place the self-adhesive electrodes on
the ankle skin with the negative (black
lead wire connector) electrode behind
the internal malleolus and the positive
electrode (red lead wire connector)
about 10 cm, above the negative
electrode as shown below.
Choose the programmes 11 or 12
(TIBN 1 or TIBN 2). Adjust intensity
level until you see your toes moving,
then reduce 1 or 2 mA. Use for 20
minutes once or twice daily.
The Sure PRO will send an electrical
impulse to the nerve. This nerve
impulse is then transmitted to the sacral
plexus which regulates the control of
bladder and pelvic floor muscles.
Warning: The TIBN 1 and
TIBN 2 programmes
designed to be used only with
self-adhesive electrode pads. Using
these programmes with a vaginal probe
could produce a too strong and
unpleasant stimulation.
When you select the TIBN 1 or TIBN 2
programmes, the intensity freezes to 1,
the warning triangle flashes and the
buttons Ch1▲ and Ch2▲ are locked.
Press 
to confirm the use of this
programme or to change programmes.

10.4. MANUAL PROGRAMMES

Warning:
healthcare professional before
using
Correct settings depend on your muscle
tone and exercise goals. Inappropriate
settings could cause discomfort or
muscle injury
incontinence.
The programmes 13, 14 and 15
(respectively CSTM 1, CSTM 2, CSTM
3) are the manual programmes.
The effect of electrical stimulation on
the body depends on a number of
settings. In these programmes you can
adjust the following:
Pulse waveform
This describes the time function of the
excitation current which may be either
monophasic
monophasic pulse trains, the current
flows in one direction. With biphasic
pulses, the excitation current alternates
are
its direction. The Sure PRO uses only
biphasic pulse trains as they reduce the
strain on the muscle, leading to less
muscle fatigue as well as safer
application, and reduce the risk of skin
irritation under the electrode.
21
Consult your
these programmes.
or aggravate Urge
or biphasic. With