Publicidad
Idiomas disponibles
Idiomas disponibles
is displayed, and the unit returns to
waiting mode.
To view the memory, press +Menu or
-Menu and cycle through parameters to
the screen with MONTH showing in the
middle and the warning triangle
bottom centre.
Use the + and -
through recordings.
To clear the memory, press and hold the
+Menu and -Menu buttons together for
3 to 5 seconds while in memory mode.
PAUSE
Pressing the ►|| button while a
programme
is
in
stimulation and the timer. The symbol
►|| is displayed. Press again to resume
the programme. Stimulation will re-start
at 75% of previous intensity setting. If
the device is left in PAUSE for more
than 15 minutes, it automatically
switches off.
OPEN CIRCUIT DETECTOR
Sure PRO controls the connections and
the contact between the probe or
electrodes and your body.
This is to avoid sudden changes in
stimulation if a broken connection is re-
established.
If the lead or probe does not have good
contact or become detached and the
intensity is set to greater than 10mA,
the warning triangle symbol
flash, the zeroes in the display will flash,
and the intensity will automatically reset
to zero.
Check the lead and try using a water-
based lubricating gel such as TensCare
Go Gel (K-GO) with the probe.
at
buttons to cycle
use
stops
the
will
27
If the problem persists, see section 20.
To preserve battery life, the Sure PRO
automatically switches off if left at zero
intensity for more than 2 minutes.
LOW BATTERY
A low battery warning symbol
will display when you need to
recharge the battery.
Automatic Keypad Lock
If no button used for 10
seconds and intensity is set
above zero the keypad will
lock
automatically.
accidental changes to settings.
Press Ch1▼ or Ch2▼button to unlock.
13. SETTING UP AND
USING THE SURE PRO
13.1. CHARGING THE
BATTERY
The Sure PRO is powered by a built-in
rechargeable Li-ion battery. A power
adaptor with interchangeable plug is
included in the kit. The battery should
need charging about once a month. The
battery should last at least 15 hours at
50mA 300μs 50Hz. To fully charge the
battery it will take about 2 hours.
When the battery is running
low, the symbol will show on
the
screen. Although
display fades as the batteries run down,
the strength of the output does not
change until the warning is shown.
This
prevents
the
Publicidad
Solución de problemas
