Installation - cecotec BOLERO DRESSCODE TOP 80 INVERTER Manual De Instrucciones

ENGLISH

3. INSTALLATION

Installation area
Fig. 3
Previous steps
Place the washing machine on a stable, flat and dry surface. Make sure the product does
-
not stand on the power cord.
Avoid direct sunlight and ensure sufficient ventilation.
-
The room temperature must be over 0ºC.
-
Choose a location away from heat sources, like gas or coal.
-
Remove the cardboard box and every packaging protecting the washing machine. Make
-
sure to remove the small foam at the bottom. If this is not possible, rest the unit on one of
the sides and remove it manually.
Remove the tape securing the power supply cord and drain hose.
-
Remove the water inlet hose from the drum.
-
Step 1. Removing the transport bolts
Warning
The transport bolts must be removed from the backside of the device before using the
-
washing machine. The guarantee does not cover faults that occur due to the use of the
machine without removing the transport bolts.
If you do not remove the bolts there may be strong vibrations, noise and defective
-
operation.
Keep the transport bolts for future transport.
-
Fig. 4-5
1. Loosen the transport bolts by turning them counterclockwise with a suitable spanner.
2. Remove the transport bolts by pulling them.
3. Insert the plastic caps provided in the holes where the transport bolts were located.
Step 2. Feet adjustment
Warning
The lock nuts on all four feet must be screwed tightly against the housing.
Fig. 6
1. Loosen the lock nut.
2. Turn the foot until it touches the ground.
3. Adjust the feet and fix the lock nuts with a spanner. Make sure the machine is levelled and
does not move.
78