Troubleshooting - cecotec BOLERO DRESSCODE TOP 80 INVERTER Manual De Instrucciones

4. Use a brush to clean the filter.
5. Install the filter again in the water supply and connect the water supply hose again.
6. Clean the inlet filter every 3 months to guarantee the normal operation of the device.
Detergent drawer cleaning
Fig. 22
1. Press the softener cover in the direction of the arrow as shown in figure 22.
2. Lift the tab, remove the softener compartment cover and wash all the slots with water.
3. Place the softener cover again and gently push the drawer into position.
Note
Do not use abrasive or corrosive products to clean the plastic parts.
-
Clean the detergent drawer every 3 months to guarantee the normal operation of the
-
device.
Cleaning the drain pump filter
Warning
Make sure the machine has finished the washing cycle and is empty. Turn it off and unplug
-
it from the mains supply before cleaning the drain pump filter.
Be careful with hot water as when cleaning the drain pump filter it is common for water to
-
be released. Wait for the water to cool down before cleaning this filter. Risk of burns
Clean the filter periodically every 3 months to guarantee the normal operation of the
-
device.
Fig. 23
1. Remove the cover in the lower part of the washing machine.
2. Remove the filter by turning it counterclockwise.
3. Remove any strange object.
4. Replace the cover.

7. TROUBLESHOOTING

Follow the indications on this table to try and solve the problem on your own before
-
contacting the Cecotec Technical Support Service.
BOLERO DRESSCODE TOP 80 INVERTER
ENGLISH
91