Publicidad
Idiomas disponibles
Idiomas disponibles
Page 10
Start / Stop Cleaning and Adjust
Cleaning Time
The factory default cleaning mode is SMART
Cycle (Floor, Wall, Waterline).
The first use of SMART Cycle (duration: 2:30),
will automatically calculate the cleaner's optimal
cleaning time for your pool. After the initial SMART
Cycle calculation, the optimal cleaning time is
saved for future use.
To recalculate the SMART Cycle setting, press
and hold the START/STOP button for 5 seconds.
Use
to change cleaning surface setting.
Toggle between:
Waterline
(45 min)
Waterline only
Quick Clean
(1h 15 min)
Floor only
SMART Cycle
(Calculate custom clean duration)
Floor, Wall, Waterline
Deep Clean
(2h 45 min)
Floor, Walls, Waterline, High Intensity
1.
With cleaner submerged in water, press
the
to begin operation. Press
again to interrupt and cancel an
in-progress cleaning cycle.
NOTE: At the beginning of each cleaning cycle, the robot
confirms your pool parameters (approximately 10
minutes). During this time, the cleaner does not
climb to the waterline.
Press +/- buttons to increase or decrease cleaning
time in 15-minute increments.
- Minimum run time is 30 minutes.
- Maximum run time is 6 hours.
NOTE: The control box automatically goes into standby
mode after 5 minutes and the display screen turns
off. Press any key to exit standby mode and view
remaining cycle time. Cleaner will continue to
function in standby mode.
Lift System
The Lift System is designed to assist in retrieving
the robot from the pool. Lift System can be activated
at any time during or after a cleaning cycle.
1.
Press
to begin the automated
procedure.
The screen displays
Lift System is in operation.
NOTE: To stop the procedure at any time, press and
release the button again.
2.
Next, Press and HOLD
cleaner.
3.
Once the cleaner is facing the wall of your
choice for retrieval, release the button.
4.
Cleaner will drive forward and up the wall it
is facing. It will wait at the water line to be
retrieved.
5.
When in reach, remove the cleaner from
the pool using the handle. The cleaner
will quickly expel water to allow for lighter,
easier removal.
NOTE: Never lift the cleaner out of the pool by the floating
cable.
Start Delay
The Start Delay is designed to allow the user to
schedule the activation of the robot cleaning cycle
by increments of an hour and up to 24 hours.
1.
After selecting cleaning surface mode,
press
and
2.
The hour will display
or
to adjust the number hours.
3.
Press
to approve the hour.
when the
to rotate the
simultaneously.
, use the
Publicidad
Solución de problemas
