Orbitalum RPG ONE Traducción Del Manual De Instrucciones Original página 48

ENGLISH
Information and safety instructions for the responsible body
DANGER!
WARNING!
WARNING!
WARNING!
WARNING!
WARNING!
48
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
Safety components that are contaminated or worn are defective!
The failure of safety components can cause physical injury.
X Do not misuse the cable, e.g. such as using it to suspend or carry the machine.
X Replace defective safety components immediately and check them daily to ensure proper
operation.
X Clean and perform maintenance on the machine after each use.
X Keep cables away from heat, oil, sharp edges and moving equipment parts.
X Inspect the machine daily for visible signs of damage or defects, and have them repaired
by a specialist if necessary.
Flying parts/breaking tool!
Diverse physical injuries and material damage.
X No damaged or deformed cutting tools (MFW) should be used.
X Firmly clamp the tube to be machined into the clamping unit.
X Immediately replace worn-out tools.
X Ensure that the cutting tools are correctly fitted.
X The inner diameter of the clamping shells must be identical to the outer diameter of the
tube to be machined. The specific inner diameter is specified on the clamping shells. The
outer diameter of the tube must be determined.
X Avoid tool breakage by ensuring low (measured) infeed (max. clamping thickness: 0.05
mm) and correct setting of speed (see chap. 9.2, p. 72).
X Check that the tool holder (WH) and multifunctional tool (MFW) are seated firmly, and
tighten if required.
Falling objects or tilting and bending tubes!
Irreversible crushing.
X Wear safety shoes (in accordance with EN ISO 20345, at least S1).
X Place sufficient supports under the tube.
X Transport the machine as shown in chap. 7.1, p. 60.
Danger caused by vibration and unergonomic, monotonous work!
Discomfort, tiredness and disruptions to the locomotor system!
Limited ability to react, and cramps.
X Do relaxation exercises.
X Ensure activity is varied.
X Assume an upright, fatigue-free and comfortable body position during operation.
Pressing the ON/OFF switch unintentionally!
Diverse physical injuries and material damage.
X At the end of each working cycle, before transportation, changing tools, cleaning and
performing any maintenance, adjustment or repair work, switch off the machine, wait
until the machine/tool stops running and pull the mains plug and/or take the recharge-
able battery out of the machine.
Liquid leaking from the battery due to wrong use!
Diverse physical injuries and material damage.
X Wash with water if touched accidentally.
X If liquid enters the eyes, contact a doctor.
RPG ONE, RPG 1.5, RPG 2.5
[REV. 20190314] OC_RPG_S_BA_790036765_00__INH-02_EN