Infeeding The Tool; Feed With Scale Divisions; Switching The Machine Off; Rpg Electric - Orbitalum RPG ONE Traducción Del Manual De Instrucciones Original

RPG ONE, RPG 1.5, RPG 2.5
NOTE!
NOTE!
9.4

Infeeding the tool

9.4.1

Feed with scale divisions

Each division means an insertion of 0.05 mm/0.002". Do not exceed clamp thickness of 0.05 mm (0.002") with chip removal.
Excessive feed levels will reduce the speed or even stop the machine ("Troubleshooting", see chap. 10.2, p. 78). Wear recom-
mended protective clothing, as described in chap. 2.4, p. 46.
1. Introduce the tool with feed (1) to the tube, until the tool
is in contact.
When the tool is cutting at the complete face of the tube:
2. Continue the tool with the same pressure further, until
the desired processing result is achieved.
3. To achieve the optimum squareness and finish, the tool
should be allowed to rotate for 2-3 revolutions without
any feed being applied.
9.5

Switching the machine off

9.5.1

RPG Electric

1. Release the ON/OFF switch (2).
The machine comes to a stop.
2. Unplug the power plug from the power source.
3. Release the tube from the machine (see chap. 8.5,
p. 68).
4. Remove the chips from the housing with suitable tools
(tongs) after each machining process.
5. Close the viewing window after removing chips.
[REV. 20190314] OC_RPG_S_BA_790036765_00__INH-02_EN
X Do not use the locking button as this inhibits the shutdown process, see chap. 9.1,
p. 71.
If the tool vibrate after starting up, the cutting speed is too high.
X Reduce the cutting speed (see chap. 9.2, p. 72).
Operation
2
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
ENGLISH
1
75