Publicidad
Idiomas disponibles
Idiomas disponibles
O R I G I N A L I N S T R U C T I O N
4. PUTTING INTO SERVICE
4.1 AIR SUPPLY
All tools are operated with compressed air at an optimum pressure of 5.5 bar. We recommend the use of pressure regulators
and filtering systems on the main air supply. These should be fitted within 3 metres of the tool (see diagram below) to
ensure maximum tool life and minimum tool maintenance.
Air supply hoses should have a minimum working effective pressure rating of 150% of the maximum pressure produced
in the system or 10 bar, whichever is the highest. Air hoses should be oil resistant, have an abrasion resistant exterior and
should be armoured where operating conditions may result in hoses being damaged. All air hoses MUST have a minimum
bore diameter of 6.4 millimetres or 1/4 inch.
Read servicing daily details page 13.
STOP COCK
(USED DURING MAINTENANCE
OF FILTER/REGULATOR UNIT)
3 METRES MAXIMUM
TAKE OFF POINT
FROM
MAIN SUPPLY
8
PRESSURE REGULATOR
AND FILTER (DRAIN DAILY)
E N G L I S H
MAIN SUPPLY
DRAIN POINT
9
Publicidad
