VALBERG 12S47 E S929C Instrucciones De Uso página 16

B
Using the appliance
Saving energy
1. Pre-rinsing of tableware items leads to increased water and energy consumption and is
not recommended.
2. Washing tableware in a household dishwasher usually consumes less energy and water
in the use phase than hand dishwashing when the household dishwasher is used according
to the instructions.
Starting a programme
1. Draw out the lower and upper basket, load the dishes and push them back. It is
commended to load the lower basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply refer to last page "Product fiche". Make
sure that the water supply is turned on to full pressure.
4. Close the door, press the Power button, to switch on the machine.
5. Choose a program, the response light will turn on. Then press the Start/Pause button, the
dishwasher will start its cycle.
Changing the program mid-cycle
• A programme can only be changed if it has been running only for a short period of time,
otherwise the detergent may have already been released or the the wash water with
detergent has already been drained. If this is the case, the dishwasher needs to be reset and
the detergent dispenser must be refilled.
To reset the dishwasher, follow the instructions below:
1. Open the door a little to stop the dishwasher, after the spray arm stopped working, you can
open the door completely.
2. Press Program button for more than 3 seconds the machine will be in program selection
mode.
3. You can change the program to the desired cycle setting.
3 sec
28 EN
B
Using the appliance
Forget to add a dish?
A forgotten dish can be added any time before the detergent dispenser opens. If this is the
case, follow the instructions below:
1. Press the Start/Pause button to pause the washing.
2. After the spray arms stopped working, you can open the door completely.
3. Add the forgotten dishes.
4. Close the door.
5. Press the Start/Pause button, the dishwasher will start.
After 5 sec
29 EN