VALBERG 6S49 F W929C Instrucciones De Uso página 18

C
Useful information
Spray arm
• It is necessary to clean the spray arm regularly for hard
water chemicals will clog the spray arm jets and bearings.
• To clean the spray arm, follow the instructions below:
1. To remove the spray arm, pull out the spray arm upward.
2. Wash the spray arm in soapy and warm water and use a
soft brush to clean the jets. Replace them after rinsing them
thoroughly.
32 EN
C
Useful information
Caring for the dishwasher
Frost precaution
• Please take frost protection measures on the dishwasher
in winter. Every after washing cycles, please operate as
follows:
1. Cut off the electrical power to the dishwasher at the
supply source.
2. Turn off the water supply and disconnect the water inlet
pipe from the water valve.
3. Drain the water from the inlet pipe and water valve. (Use a
pan to gather the water)
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and use a sponge
to soak up water in the sump.
After every wash
• After every wash, turn off the water supply to the appliance
and leave the door slightly open for a while so that moisture
and odors are not trapped inside.
33 EN