VALBERG 6S49 F W929C Instrucciones De Uso página 20

C C
Useful information Useful information
Problem Possible causes
Improper detergent
Foam in the tub
Spilled rinse aid.
Detergent with colourant
Stained tub interior
may have been used.
White film on inside surface Hard water minerals.
The affected items are not
corrosion resistant.
A program was not run after
There are rust stains on
dishwasher salt was added.
cutlery
Traces of salt have gotten
into the wash cycle.
The lid of the softer is loose.
Knocking noise in the wash The spray arm is knocking
cabinet against an item in a basket.
36
Solution
• Use only the special
dishwasher detergent to
avoid suds. If this occurred,
open the dishwasher and
let suds evaporate. Add 1
gallon of cold water to the
tub. Close and latch the
dishwasher, then Start any
wash cycle to drain out the
water.
• Repeat if necessary.
• Always wipe up rinse aid
spills immediately.
• Make sure that the
detergent has no colourant.
• To clean the interior, use
the damp soft cloth with
dishwasher detergent and
wear rubber gloves. Never
use any other cleaner than
dishwasher detergent for
the risk of foaming or suds.
• Avoid washing items that
are not corrosion resistant
in the dishwasher.
• Always run the quick
wash program. without any
crockery in the dishwasher
and without selecting the
Turbo function (if present),
after adding dishwasher
salt.
• Check the lip. Ensure the
fix is fine.
• Interrupt the program,
and rearrange the items
which are obstructing the
spray arm.
EN
C C
Useful information Useful information
Problem Possible causes
Rattling noise in the wash Item of crockery are loose
cabinet in the wash cabinet.
This may be caused by
Knocking noise in the water
on-site installation or the
pipes
cross-section of the piping.
The dishes were not loaded
correctly.
The program was not
powerful enough.
Not enough detergent was
dispensed.
Item are blocking the path
The dishes are not clean
of spray arms.
The filter combination in
the base of wash cabinet is
not clean or is not correctly
fitted. This may cause
the spray arm jets to get
blocked.
Combination of soft water
Cloudiness on glassware.
and too much detergent.
Black or grey marks on Aluminium utensils have
dishes rubbed against dishes
Detergent left in dispenser Dishes block detergent
cups dispenser cups
37
Solution
• Interrupt the program,
and rearrange the items of
crockery.
• This has no influence on
the dishwasher function. If
in doubt, contact a qualified
plumber.
• See "Preparing And
Loading Dishes".
• Select a more intensive
program.
• Use more detergent, or
change your detergent.
• Rearrange the items so
that the spray can rotate
freely.
• Clean and/or fit the filter
correctly. Clean the spray
arm jets.
• Use less detergent if you
have soft water and select
a shorter cycle to wash the
glassware and to get them
clean.
• Use a mild abrasive
cleaner to eliminate those
marks.
• Re-loading the dishes
properly.
EN