Servicing And Maintenance Instructions; Technical Features - STAYER WELDING POTENZA TIG 170 HF GE Manual De Instrucciones

5.- SERVICING AND MAINTENANCE
INSTRUCTIONS
CLEANING, MAINTENANCE, LUBRICATION, SHARPENING.
For cleaning, always disconnect the equipment and wait at
least 10 minutes for the sake of safety regarding the discharge
of the power capacitors. Clean the housing using a slightly wet
cloth. Depending on the pollution of the work environment or at
least each 1000 hours, clean the inside with dry pressurized air,
removing the upper housing and removing dust, metal pollutants
and fluff, paying special attention to the dissipators and the fan.
The equipment does not need special maintenance by the user,
whereby careful use within the environmental limits is the best
guarantee for long years of safe service. It is recommended to
send the equipment to the technical services after each 3000
work hours or every 3 years for verification and recalibration.
REPAIR SERVICES WITH DIRECTIONS.
The technical service staff will advise you with all the doubts and
questions you may have about the reparation or the maintenance
of your product, just as with replacement components. All the
illustrations and lists of parts of the unit are also available in the
web from: info@grupostayer.com
Our technical advisors' team will gladly guide you about
acquisition, application and adjustment of the products and
accessories.
List of user-replaceable parts
Due to the complexity and potential hazard, qualified intervention
is required, except for minor repairs as inspection of connections
and replacement of the standard power supply plug and revision
of the welding cables, which thus are not considered user-
replaceable parts..
6.- REGULATIONS

TECHNICAL FEATURES

= tension input
= current input
= current output
%
= work cycle
ON
OFF
EN60974
- -
= mass
= dimensions
- -
= generator power
ENGLISH
40
40