Publicidad
E N G L I S H
Loading the Tool
•
Connect the air supply to the tool.
•
Open tail Jaws 9 which grip the mandrel, by switching off the tail jaw switch (items 26, 29 and 30).
•
Screw selected nose jaws onto Barrel 25 of the tool.
Insert a mandrel into the tail end of the fasteners through the paper pod.
•
Slide the mandrel follower spring onto the mandrel ensuring correct orientation, as shown in the table on page 11.
•
Gripping the tail end of the mandrel, tear off the paper pod from around the fasteners.
•
Open the nose jaws either by rotating the outer ring on Cam operated jaws or by pushing outwards on the jaw ends, as
illustrated below left.
•
Insert the previously assembled mandrel, mandrel follower spring and fasteners into the nose jaws until the fi rst fastener
to be placed is protruding from the nose jaw.
•
Close the nose jaws and adjust so that the fi rst fastener protrudes by 1.5mm - 3mm (1/16" to 1/8"), as shown in the
illustration below right.
•
Close the tail jaws to ensure the mandrel is gripped, by switching on the tail jaw switch (items 26, 29 and 30).
Reloading the Tool
•
Open tail Jaws 9 of tool.
•
Open the nose jaws and pull the empty mandrel and mandrel follower spring out of the tool.
•
Reload the tool by following the above instructions, starting at stage.
4.4 OPERATING PROCEDURE
You must check that the cursor orientation and the nose equipment are correct before attempting
•
Push the fastener, protruding from the nose jaws, fully into the application holes ensuring that the tool is held square.
•
Operate the trigger without releasing - the mandrel head is pulled through the fastener, forming the fastener into the
application.
•
Remove the tool.
•
Release the trigger. The next fastener will be automatically presented through the nose jaws, ready for placing.
Item numbers in bold refer to the general assembly and parts list for the 07535-02500 MkII type on pages 15 and 16.
4.5 PLACING EQUIPMENT
All nose equipment, mandrels, follower springs and other accessories can be found in the accessories manual (part number
07900-09508)
10
IMPORTANT
to operate the tool.
O R I G I N A L I N S T R U C T I O N
1.5mm - 3mm
1
1
(
" -
")
/16
/8
Publicidad
