Preparation For Operation - hillvert HT-LOGAN-750B Manual De Instrucciones

3.2.
LOCATION OF THE DEVICE
The ambient temperature must not exceed 45°C and ambient humidity should not
exceed 85%. Use the device in properly ventilated spaces. Do not block the air outlet
of the device. Keep the device away from any hot surfaces.
ASSEMBLY OF THE DEVICE
Maintenance or assembly works with the running engine are prohibited.
Assembly of the leaf vacuum cleaner
1. Connect the vacuum cleaner tubes together by inserting their ends into each
other paying attention to the splines and grooves on the tubes. Lock the
connection by turning.
2. Remove the screw that secures the fan cover.
3. Open the fan cover. Install the vacuum cleaner tube in the air inlet paying
attention to the splines and grooves on the tube and housing.
4. Install the connection elbow by placing the end (a) in the air outlet hole and
by turning appropriately (secure the connection using the M4x16 screw),
place the end (b) in the hole in the leaf bag (lock the elbow to protect it from
falling out by closing the zipper).
3. Handle
4. Fan cover fixing screw
5. Fan cover
6. Leaf bag
7. Connection elbow
8. Blower fan tube
9. Vacuum cleaner tube
10. Spark plug
11. Starter cord holder
12. Fuel tank
13. Fuel filler cap
14. Idle adjustment screw
15. Air filter cover

Preparation for operation