Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance and care of open (wet-cell) batter-
ies
Notice:
Caring for maintenance-free batteries only entails
following proper charging procedures and config-
uring the charging curve correctly.
Open battery compartment for maintenance
• The machine must be switched off and the key must be re-
moved.
Warning:
Before opening the battery compartment make sure
that both tank areas are empty.
• Lower the suction nozzle.
• At the bottom left and right on the
front side of the machine you will find
the battery compartment release.
• Unscrew both screws and remove
them.
• Stand on the left side of the machine.
• Hold the recessed grip (1) with one
1
hand and the driving handle (2) with
the other and carefully open the bat-
2
tery compartment until the driving
handle lies on the ground.
Warning:
After maintenance, carefully bring the tank back to
its initial position and reattach the screws.
Notice:
Lift the suction nozzle again
Notice:
Put the key back in place.
Prior to commissioning
Relocation drive
• Switch on the machine (key switch).
• Take the driving handle and position the hands in such a
way that you can work easily with them.
• By gently pushing the driving switch
into the direction of movement, the
machine is set into motion. If you let
go of the driving switch, the machine
will stop.
Brush installation
Before inserting, please check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
Caution:
Do not use brushes which have reached their wear
limit. The wear limit is indicated by the length of the
red bristle. Do not use worn or contaminated pads.
Use original TASKI brushes only.
Failure to observe these instructions may result in inad-
equate cleaning results or even floor damage.
Single- and Double disc Deck
• Position the tools under the tool unit.
• Switch the machine on.
The indicator elements lights up briefly.
Variant: Automatic brush lowering
• Press the Brush drive button ON/
OFF.
While lowering the brush drive will
slowly start to pulse. In this way the
tool is centered and engaged.
The display lights up.
Variant: Foot pedal
• Unlock the foot pedal and lower the
tool slowly.
While lowering the brush drive will
slowly start to pulse. In this way the
tool is centered and engaged.
The brush drive display lights up
Notice:
When the brush is down, gently moving the ma-
chine back and forth can make the clutch easier to
engage.
9
Publicidad
