MedLinket AM801 Manual Del Usuario página 13

● SpO2 measurement
1) Open the clip of PULSE OXIMETER, See figure 5.①.
2) Place a finger ( The preferred application is middle finger and index finger) on
the silicone and ensure the finger position is correct , see figure 5.②, and then
clamp the finger, see figure 5.③.
3) Turn on the PULSE OXIMETER by pressing the Power button "
4) Get the information of SpO2 directly from screen display.
①
Note:
1. The detail of setting see table - 1.
2. When put finger into the silicone cushions of the clip, make sure nail is
upturned.
● Temperature measurement
1) Plug the temperature probe connector side into the instrument's USB
female connector , and then place another side of the temperature probe to
patient's surface or Esophageal/Rectal for collecting the temperature signal.
2) Get the information of Temperature directly from screen display.
● Switch screen display mode
1) Press the Display mode switch, See figure 6.
②
Figure 5: measurement
97 75
%SpO
BPM
2
Figure 6
English 13
"
③