Final Installation - Audi 8U0 054 630 Manual De Montaje

1.6 Setup Troubleshooting
Note
If the fault has been found and rectified, the parking distance control system must be set up again.
1.5 Setting up the parking distance control system
If there is no tone after switching on the ignition and engaging reverse gear, check the power supply wiring,
the connections on the control unit and the reversing light bulb.
Note
If the reversing light bulb is defective, the power to the reversing light is cut off by the vehicle's own control
unit. A fault is indicated in the dash panel insert. In this case, the parking distance control system will also
not work.
Page 5 – Fig. 1
With reverse gear engaged, is the supply voltage to connector -2- 12V?
Troubleshooting as per the wiring diagram
Is the buzzer connector plug -4- connected correctly?
Is the blue single wire of the power supply wiring harness already cut? If necessary, reconnect.
If a single, drawn-out tone does not sound after the double beep (start of the learning process) within a
max. of 100 seconds to confirm the end of the learning process, check the sensor connections.
If a single, drawn-out tone does not sound after the double beep (start of the learning process) within a
max. of 100 seconds to confirm the end of the learning process, but an intermittent beep is heard instead,
then the obstacle behind the vehicle has not been detected.
Check the distance to the wall, correct as necessary, or align with another obstruction at a distance of
50 cm.
1.7

Final installation

 Secure all the parking distance control system wires to existing wires or holders to avoid noises.
 Fit the right luggage compartment side trim, the rear hatch trim and the luggage compartment floor mat
in the reverse order.
Interior bodywork fitting; Repair Group 68; interior fittings
21