Starting / Stopping The Engine - Stihl TS 700 Cutquik Manual De Instrucciones

Ocultar thumbs Ver también para TS 700 Cutquik:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English / USA
Change the fuel pick-up body
every year
:
Drain the fuel tank
:
Pull the fuel pick-up body out of the
tank with a hook and disconnect it
from the hose
:
Connect a new fuel pick-up body to
the hose
:
Return the fuel pick-up body to the
tank
34
Starting / stopping the
engine
:
Note the safety instructions. Refer
to the chapter headed "Safety
precautions and working
techniques".
:
Press the throttle trigger
interlock (1) and throttle trigger (2)
at the same time.
:
Hold both triggers down.
:
Move the slide control (3) to START
and hold it in position too.
:
Then release the throttle trigger,
slide control and throttle trigger
interlock in succession =
starting throttle position
:
Set choke lever (4):
if engine is cold, to T
if engine is warm, to e
(even if the engine has already been
running but is still cold or if the hot
engine has been switched off for
less than 5 minutes).
If engine is hot (if the hot engine has
been switched off for more than
5 minutes), to o.
:
Press the button of the
decompression valve (5) – this
button must be pressed again
before each fresh attempt to start
the engine.
:
Press the fuel pump bulb (6) 7–10
times, even when the bulb is filled
with fuel.
TS 700, TS 800

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Ts 800 cutquik

Tabla de contenido