Replacing The V-Belt; Stihl Cut-Off Machine Cart - Stihl TS 700 Cutquik Manual De Instrucciones

Replacing the V-belt

4
2
6
1
5
6
6
: The arrow on the tensioning nut (1)
must point to "0". Turn the
tensioning nut anticlockwise
with the combination wrench –
approx. 1/4 turn, until it reaches "0".
: Remove the hexagon bolts (2).
: Pull the V-belt guard (3) off to the
front and remove the V-belt from the
front pulley.
: Remove the bearing and guard.
: Remove the hose from the guide (4)
in the starter cover (5).
: Remove the screws (6) from the
starter cover.
: Remove the starter cover.
: Remove the defective V-belt from
the cast arm.
TS 700, TS 800
3
: Carefully fit a new V-belt (7) in the
cast arm and in the V-belt pulley (8)
on the power unit.
: Fit the starter cover.
: Hold the bearing with guard against
the cast arm.
: Insert the V-belt in the V-belt
pulley (9).
: Refit the V-belt guard.
: Line the threaded holes in the
bearing up with the oblong holes in
the cast arm and with the holes in
the V-belt guard.
: Screw in the hexagon bolts, but do
not tighten them yet.
: Fit the hose in the guide in the
starter cover.
Continue as described in the chapter
"Tensioning the V-belt".
English / USA

STIHL cut-off machine cart*

The cut-off machine can be mounted on
the STIHL cut-off machine cart FW 20 in
a matter of minutes.
The cut-off machine cart makes it easier
to
– repair damaged carriageways
– apply carriageway markings
– cut expansion joints
* Special accessory
43