Lavorwash EVO 850 Manual De Instrucciones página 41

Remove the tank cover (ITEM 22 FIG.3) and fill the tank to the rim.
The water level is easily visible from the indicator (RED dot) located inside the clear clean water drain
pipe (ITEM 23 FIG. 3).
DO NOT MIX THE DETERGENT IN THE TANK AND INSTEAD USE ONLY WATER
USE ONLY LOW FOAM, NON-FLAMMABLE LIQUID DETERGENTS, SUITABLE FOR THE
APPLIANCES IN USE
BEFORE USING THE MACHINE, ALWAYS ADD ANTI-FOAM PRODUCTS TO THE TWO DIRTY
WATER TANKS!
The water temperature must not exceed 54.4 degrees Celsius (130 degrees Fahrenheit)
To activate the detergent dispensing system, turn the switch clockwise, ITEM C FIG. 2, from the flow stop
position "OFF" to the dosage percentage positions indicated:
0 .5% -1% - 1,5% - 2% - 3% - 4% - 5% .
It is advisable to increase/decrease the dosage of the anti-foam additive according to
the percentage of detergent dispensing.
The type and percentage of detergent to be used will be evaluated according to the type of surface and dirt to
be treated. If you are not working on very dirty floors, use percentages not exceeding 0.5-1-2%.
FIG. 5
FILLING THE SOLUTION TANK
ELECTRONIC DOSAGE
41