Metz SCA 3083-M2 digital Manual De Instrucciones página 12

4. Zoom reflector position of the mecablitz
mecablitz 40 MZ-..., 44 MZ-2, 50 MZ-5,
54 MZ–3, 70 MZ-...:
After the slave adapter has been mounted and the
mecablitz switched on, the flash unit will automati-
cally set the reflector to 24 mm position (28 mm on
the 44 MZ-2) to provide the widest possible flash
coverage. The reflector position of the mecablitz
can be changed manually should this be required
(see mecablitz operating instructions). If such a
change is made, the position of the reflector
flashes on the LC display. The 24 mm setting
(28 mm on the 44 MZ-2) will automatically be re-
established when the mecablitz is switched off and
on again. The reflector position indicated on the LC
display will then no longer flash.
mecablitz 32 MZ-3:
The setting slide
mecablitz must be set at "CZ". The zoom reflector
automatically switches to 28 mm.
mecablitz 32 Z-2:
The reflector of the mecablitz must be set manual-
ly to 28 mm.
Various mecablitz models featuring a zoom
reflector permit the reflector position to be
adjusted manually for adaptation to the focal
length of the camera lens (see mecablitz oper-
ating instructions). Such an adapting operation
is not necessarily required in slave mode.
12
for the zoom reflector of the