Metz SCA 3083-M2 digital Manual De Instrucciones página 19

Two remote control channels are available to en-
sure that two different Metz Remote Systems do
not interfere with each other when in the same
room. The master (controller) and the slaves of the
Metz Remote System must be operating on the
same remote channel. The adjusted channel is
indicated on the LC-display of the mecablitz as fol-
lows:
Controller (master flash unit):
The mecablitz LC-display indicates "Co1" or "Co"
+ "Ad1" for remote channel 1.
The mecablitz LC-display indicates "Co2" or "Co"
+ "Ad2" for remote channel 2.
Slave flash unit:
The mecablitz LC-display indicates "SL1" or "SL" +
"Ad1" for remote channel 1.
The mecablitz LC-display indicates "SL2" or "SL" +
"Ad2" for remote channel 2.
The Metz remote flash mode is not possible
when the secondary reflector is activated. In
this instance the sensor
er will start to flash as a warning signal.
Switch off the secondary reflector!
The LC-display of the mecablitz (both controller
and slave) will not indicate distance ranges when
in Metz remote flash mode.
of the slave adapt-
19