ARDEA ONE CL200x-38 Manual De Instrucciones página 34

14
N.B. Check inclination of the seat after installing the different wheels, compensating for any
difference in height by adjusting the rear wheels.
16.8 Wheels for narrow passageways (CLA221)
16.9 Roll-over protection wheels (CLA220)
16.10 Push rings with supergrip (CLA232)
16.11 Unpierceable rear wheels (CLA230)
Remove the rear wheels, identify the height of the support of the small
wheels for narrow passageways, open any pre-cut holes on the frame
to insert the through bolts. Tighten the bolts completely. Reinsert
the rear wheels and check that the small wheels are not touching the
ground.
Remove the rear wheels, identify the height of the support of the roll-
over protection wheels, open any pre-cut holes on the frame to insert
the through bolts. Tighten the upper bolts completely. Reinsert the
rear wheels and incline the support of the small wheels to the desired
position, insert the knob screw in the support of the frame and tighten
it completely.
Insert the push rings into the self-propelling ring present on the outer
part of the wheels.
Remove the rear wheels by pressing the quick-release button, remove
the pins and reinsert them in the holes on the frame of the replacement
wheel, checking that they are properly inserted.
N.B. If original spare parts are used, the wheel pins are compatible
with all MORETTI S.p.A. models.