Breville the Barista Express Impress Manual De Instrucciones página 28

Do not use abrasive cleansers, pads or cloths
which can scratch the surface. Do not clean any
of the parts or accessories in the dishwasher.
CLEANING THE OUTER HOUSING
& CUP WARMING TRAY
• The outer housing and cup warming tray
can be cleaned with a soft, damp cloth. Polish
with a soft, dry cloth. Do not use abrasive
cleansers, pads or cloths which can scratch
the surface.
STORING YOUR MACHINE
• Before storing, press the POWER button to off,
turn the steam dial to STANDBY switch Off at
the power outlet and unplug. Remove unused
beans from the hopper, clean the grinder,
empty the water tank and the drip tray.
• Ensure the machine is cool, clean, and dry.
Insert all accessories into position or into
the storage tray. Store upright. Do not place
anything on top.
WARNING
To prevent damage, do not use alkaline
cleaning agents when cleaning. Use a
soft cloth and a mild detergent.
WARNING
Do not immerse power cord, power plug
or appliance in water or any other liquid.
The water tank should never be removed or
completely emptied during decalcifying.
USING THE ALLEN KEY
Over time, the silicone seal surrounding the
shower screen will need to be replaced to
ensure optimum brewing performance.
1. Press the POWER button to switch the
machine off and unplug the cord from the
power outlet.
2. Carefully remove the water tank and drip
tray, taking particular care if they are full.
3. Using a skewer or similar, clean the center
of the screw of any residual coffee.
28
4. Insert the shorter end of the Allen
Key into the center of the screw. Turn
counterclockwise to loosen the screw.
Clean centre of screw
before inserting Allen Key
5. Once loosened, carefully remove, and retain
the screw and stainless-steel shower screen.
Make note of the side of the shower screen
that is facing downwards. This will make
re-assembly easier. Wash the shower screen
in warm soapy water, then dry thoroughly.
6. Remove the silicone seal with your fingers
or a pair of long-nose pliers. Insert the new
seal, flat side first, so the ribbed side is
facing you.
7. Re-insert the shower screen, then the screw.
With your fingers, turn the screw clockwise
for 2-3 revolutions then insert the Allen Key
to tighten until the screw is flush with the
shower screen.
8. Re-insert the drip tray and water tank.
NOTE
Contact Breville Customer Service or visit
www.breville.com for replacement silicone
seals or for advice.