Publicidad
Idiomas disponibles
Idiomas disponibles
USE/OPERATION
MAGNETIC SMART KEY
BATTERY CHECK/SETTING ON A NEW MACHINE
BATTERY INSTALLATION
revised 07/2017
11/2014
Batteries already installed on the machine
Without batteries
Battery Installation
WARNING!
– DANGER
– WARNING
– CAUTION
– CONSULTATION
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates (see Visible Symbols On
The Machine paragraph).
Battery Charging
Do not cover these plates for any reason and immediately replace them if damaged.
A magnetic smart key (52) is required to start the machine. If the start switch (42) is pressed and the key is not in the key reader
(41), the display will turn on temporarily and it will show a key insertion request, then it will turn off.
There are two different magnetic smart keys:
1.
User key (blue) for scrubbing/drying operations and basic information.
2.
Supervisor key (yellow) for accessing additional features (see the Supervisor key paragraph in Maintenance chapter).
WARNING!
The machine requires 2 12 V batteries, connected according to the diagram shown in Figure 1.
The machine can be supplied in one of the following modes:
1.
Ensure that the battery connector (9) is connected.
2.
1.
Retailers.
2.
Set the machine according to the type of batteries installed as shown in the Supervisor key section of the Maintenance
chapter.
1.
Remove the user key (52).
2.
Disconnect the battery connector (9).
3.
Lift the cover (34) and check that the recovery tank (33) is
empty; if not, empty it using the drain hose (12).
4.
Close the cover (34).
5.
Grasp the handle (16) and carefully lift the tank (33).
6.
The machine is supplied with cables suitable to install
2 12 V batteries. Carefully lift the batteries up to the
compartment, then install them correctly.
7.
Route and install the battery cable as shown in Figure 1,
then carefully tighten the nut on each battery terminal.
8.
Connect the battery connector (9).
9.
Grasp the handle (16) and carefully lower the tank (33).
10. Fully charge the batteries (see the procedure in
Maintenance chapter).
On some points of the machine there are some adhesive plates indicating:
The electric components of the machine can be seriously damaged if the batteries are either improperly installed
or connected. The batteries must be installed by qualified personnel only.
Check the batteries for damage before installation.
Handle the batteries with great care.
When first using the machine with new batteries, perform a full charging cycle (see the procedure in Maintenance chapter).
Buy appropriate batteries (see "Technical Data" paragraph). For battery choice and installation, apply to qualified battery
INSTRUCTIONS FOR USE
9099980000 - SC500
Figure 1
ENGLISH
11
P100841
Publicidad
