Publicidad
Idiomas disponibles
Idiomas disponibles
revised 07/2017
Brush or pad-holder removal/installation (REV system)
11/2014
Squeegee installation
1.
Make sure that the REV deck (37) is lifted.
2.
Turn off the machine and remove the user key (52).
3.
According to the kind of cleaning to be performed, install
the pad (A, Fig. 3) or the brush (C, optional) and note the
following:
•
Place the pad (A) under the deck and press it until it is
fastened with the Velcro of the drive disc (B).
•
Place the brush (C, optional) under the deck, and then
match the centering pins (D) to the respective holes of
the drive disc (B), and then engage the brush with the
three mounting screws (E).
4.
To remove the pad or brush, proceed in the reverse order.
1.
Install the squeegee (A, Fig. 4) and fasten it to the bracket
(C) with the handwheels (B).
2.
If necessary, adjust the squeegee with the knob (D) so that
CAUTION!
detergents, intended for automatic scrubber
WARNING!
the instructions on the labels of the detergent
NOTE
If the machine is equipped with EcoFlex system pour
clean water in the tank, otherwise pour solution.
1.
Ensure that the solution valve (18) is open (18-A).
2.
the rear blade (E) and front blade (F) touch the floor as
shown in the figure.
Solution tank filling
Use only low-foam and non-flammable
applications.
When using floor cleaning detergents, follow
bottles.
To handle floor cleaning detergents, wear
suitable gloves and protections.
To fill the solution tank (21) use the front filler (22), or open
the cap (24) to access the side filler.
INSTRUCTIONS FOR USE
9099980000 - SC500
Figure 3
Figure 4
C
D
F
ENGLISH
13
P100857
P100843
B
A
E
C
A
B
D
B
E
Publicidad
