Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Adjusting of detergent concentration in the washing
water
EcoFlex system
16
REV system (for REV version only)
Working with brush extra pressure function turned on
(For machines with EcoFlex system)
The system for mixing the detergent in the washing water is
automatically activated when the brush is running.
The percentage of detergent added to the washing water is set
to level 1 (Fig. 7).
By pressing the push-button (50), it is possible to set the
percentage level to 2, or reset it to level 0.
The set percentages are shown on the display (51-H).
Press the EcoFlex push-button (47) when stronger washing power is needed temporarily.
increase in the solution detergent concentration (level 2 if the level was set to 1 - level 1 if the level was set to 0) is obtained.
Press the EcoFlex push-button (47) again, to restore the original settings (LED on).
NOTE
NOTE
With the REV system activated the drive speed is decreased, the brush extra pressure is activated, the detergent is stopped and
the washing water quantity is reduced.
following procedure:
1.
Press the One-Touch push-button (43) to lower the brush deck as shown in "Starting The Machine" paragraph.
2.
Press and hold the One-Touch push-button (43) for more than 1 second. The extra pressure function activation is shown by
LED which turns from green to red, and by the icon
3.
To return to normal pressure, press and hold the One-Touch push-button (43) for more than 1 second.
4.
To lift the brush deck without returning to the normal pressure, press the One-Touch push-button (43) and release it
immediately.
CAUTION!
With the EcoFlex system activated (LED flashing), increased solution flow, activation of the extra pressure of the brush and an
If the EcoFlex push-button (47) is not pressed again, the original settings are restored automatically after 60 seconds.
All of the above solution flow and detergent concentration values are factory settings.
To change these settings, see the Supervisor key section in the Maintenance chapter.
Press the REV push-button (45) when a specific washing mode is required.
If the floor proves to be particularly difficult to clean, it is possible to turn on the brush extra pressure function, according to the
In case of brush motor overload, due to foreign bodies which prevent them from turning, or to excessively
aggressive floors/brushes, the safety system stops the brush after about one minute of continuous overload.
If the overload takes place when the extra pressure function is on, the system automatically turns the extra
pressure function off.
If the overload persists, the brush stops.
To start scrubbing again after a brush stop due to overload, turn off and then on the machine with the push-
button (42).
INSTRUCTIONS FOR USE
SC500 - 9099980000
on the display (51).
Lev.
1
revised 07/2017
Figure 7
Lev.
2
Lev.
0
OFF
11/2014
P100846
Publicidad
