Nilfisk Advance SC500 Instrucciones De Uso página 16

MACHINE START AND STOP
ENGLISH
(For machines without EcoFlex system)
(For machines with EcoFlex system)
14
Starting the machine
Stopping the machine
3. Fill the tank (21) with a solution suitable for the work to be performed.
Always follow the dilution instructions on the label of the chemical product used to prepare the solution.
The solution temperature must not exceed 40 °C.
4.
The water temperature must not exceed 40 °C.
5. Lift the cover (34) and check that the recovery tank (33) is empty; if not, empty it using the drain hose (12).
6. Close the cover (19).
7. Grasp the handle (16) and carefully lift the tank (33).
8. Fill the tank (25) with a detergent suitable for the work to be performed (highly concentrated detergent).
CAUTION!
NOTE
1. Prepare the machine as shown in the previous paragraph.
2. To turn on the machine, place the user key (52) in the key reader (41), then press the push-button (42).
3.
batteries installed (51-B).
NOTE
Check the battery charge level.
ready for use.
Maintenance chapter).
4. Drive the machine to the area it is required by starting it with your hands on the handlebar (1) and pushing the paddle (2)
forward to move forward, and backwards to move in reverse. The speed can be adjusted by pressing the paddle (2) more or
less. The maximum speed can be set with the push-buttons (46).
5. Stop the machine by releasing the paddle (2).
6. Turn off the machine by pressing push-button (42), then remove the user key (52).
NOTE
complete idle.
NOTE
7. Make sure that the machine cannot move independently.
CAUTION!
Do not fill the tank completely, leave a few inches from the edge. Use the level hose (13) as reference.
Fill the tank (21) with clean water. Use the water removable filler hose (23).
Do not fill the tank completely, leave a few inches from the edge. Use the level hose (13) as reference.
Detergent tank filling (For machines with EcoFlex system)
Do not fill the detergent tank completely, leave a few inches from the edge.
Use only low-foam and non-flammable detergents, intended for automatic scrubber applications.
To accelerate filling of the hoses and system operation (with a new system, if the system has been emptied for cleaning,
etc.), it is a good idea to drain the EcoFlex system once or several times (see the procedure in the Maintenance chapter).
In the first 2 seconds after machine start-up, the display (51) indicates the machine working hours (51-A) and the type of
When the display shows at least one segment of the battery symbol (51-C) which is on but not flashing, the machine is
When the battery symbol (51-C) shows just one segment flashing, the batteries have to be charged (see the procedure in
The machine is running without the user key (52) in the key reader (41), it automatically switches off after 10 seconds of
If the machine is on but not working, it automatically turns off after 5 minutes.
In the event of an emergency when you must stop all machine functions immediately, disconnect the battery
connector (9).
Reset the machine functions by connecting again the connector.
INSTRUCTIONS FOR USE
SC500 - 9099980000
revised 07/2017
11/2014