Accessories; 1) Optical Wand; 2) Usb Memory Drive; Intended And Non-Intended Use - Integrity I Fuse 105 Manual Del Usuario

6.4)

Accessories

6.4.1) Optical wand

If looking for wand's technical features usable on this electronic device, please contact Integrity Fusion Products, Inc.
service

6.4.2) USB Memory Drive

Can be used memory drive (USB key) normally present on the market. In order to work properly with our device,
technical requirements are:
• ≥ 1 Gbyte memory capacity
• Formatting FAT 16/32
7) Trasporting and handling
ECU shall be transported using the supplied box. Do not knock the machine and do not damage the body. In case of damage or
bruising, do not connect to the fusion power supply and contact the service center. Be very careful moving ECU. Switch off ECU
using the switch before disconnecting to the input voltage.
8) Storage
If possible, ECU have to be preserved in its supplied box. Avoid exposure to temperatures above 60 °C / 140 °F and lower than
- 20 °C / - 4 °F. The storage place should be dry, not humid.
9) Disposal
This ECU and its packaging should be recycled respecting the environment.
This symbol means: Do not throw the electrical tools in household waste.
According with the European Directives 2002/95/EC and 2002/96/EC - concerning the restriction of hazardous
substances (RoHS) and the treatment of electrical and electronic waste equipment (WEEE) and their application
to national rights - equipment and electrical tools that are no longer usable must be collected separately and
disposed respecting the environment. The owner of this machine must use the disposal method using in its
territory. Please note that there are the presence of aluminum (frame) and copper (transformer) between recyclable materials.
10) Functioning and use
10.1)

Intended and non-intended use

This ECU is designed to operate in environmental and supply conditions indicated in the table showing technical data
(paragraph 4). It's an electronic device which must be exclusively used to provide the required energy for electrofusion
fittings. The supply circuit must be connected to an electrical system with protection. The electrical circuit supplying
current to the fittings is a PELV (Protected extra low voltage) "safety low voltage" and it can be used in areas defined as
"restricted conductors" (e.g.: excavations with presence of humidity). Integrity Fusion Products, Inc. is not responsible for
any other use not covered in this handbook.
Pag. 13/50