Installation; Prior To Use; Your Refrigerator - Sears Kenmore 795.7160 Serie Manual De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION
• To minimize
noise and vibration,
the refrigerator
MUST be installed
on a solidly constructed
floor.
• Carpeting
and soft tile surfaces
are not
recommended.
• Never install the refrigerator
on a platform
or
weakly
supported
structure.
1. To avoid vibration,
the unit must be leveled.
If required,
adjust the leveling
legs to compensate
for unevenness
of the floor. The front should
be
slightly
higher than the rear to aid in door closing.
Leveling
legs can be turned easily by tipping the
cabinet
slightly. Turn the leveling
legs clockwise
( .L._ ) to raise the unit, counterclockwise
( _,m. )
to lower it.
(See Leveling
and Alignment
on page 17.)
2. Install this appliance
in an area where the
temperature
is between
55°F (13°C) and 110°F
(43°C.) If the temperature
around the appliance
is
too low or high, cooling
ability may be adversely
affected.
3. Too small a distance
from adjacent
items may
result in lowered
freezing
capability
and increased
electricity
consumption
charges.
Allow at least 24
inches (61 cm) in front of the refrigerator
to open
the doors.
PRIOR TO USE
1. Clean your refrigerator
thoroughly
and wipe off all
dust accumulated
during shipping.
2. Install accessories
such as ice cube bin, drawers,
shelves,
etc., in their proper places. They are
packed together
to prevent
possible
damage
during shipment.
3. Let your refrigerator
run for at least 2 or 3 hours
before putting food in it. Check the flow of cold air
in the freezer compartment
to ensure
proper
cooling.
Your refrigerator
is now ready for use.
2" (5.08 cm)-_
10

Publicidad

Tabla de contenido
loading

Tabla de contenido