Start The Icemaker - Sears Kenmore 795.7160 Serie Manual De Uso Y Cuidado

8. FLUSH OUT THE TUBING
Turn the main water supply on
and flush out the tubing until the
water is clear.
Shut the water off at the water
valve after about one quart of
water has been flushed through
the tubing.
10. TURN THE WATER ON AT THE
SHUTOFF VALVE
Tighten any connections that leak.
9. CONNECT THE TUBING TO THE
REFRIGERATOR
NOTE: Before making the connection to the
refrigerator, be sure the refrigerator power
cord is not plugged into the wall outlet.
1. Remove the plastic flexible cap from the water
valve.
2. Place the compression nut and ferrule (sleeve)
onto the end of the tubing as shown.
3. Insert the end of the copper tubing into the
connection as far as possible. While holding the
tubing, tighten the fitting.
_, CAUTION: Check to see if leaks occur at water
line connections.
Tubing Cla_
1/4" \ /
Compression _
III
Nut _
1/4" Tubing
l
(sleeve)
Refrigerator
Connection
11. PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not
vibrate against the back of the refrigerator or
against the wall. Push the refrigerator back to
the wall.
12. START THE ICEMAKER
Set the icemaker power switch to the On (I)
position.
NOTE: A newly installed refrigerator may take
several hours to start producing ice.
_, CAUTION: Check to see if water dripping
occurs at water line connections.
30