Magneti Marelli Vision Guida Rapida página 42

 „Analisis‟. Using the following buttons, you can:
 „Trigger‟.
Within this environment you can set the signal acquisition point.
MULTIMETER
With the multimeter function you can take voltage and resistance
measurements (fig. 6). The multimeter uses the same ports and
cables as the oscilloscope. To correctly perform the functions,
always make sure you are using the ports and cables of the colour
indicated by the software.
Press
unit scale is automatic, no width changes are required.
Press
unit scale is automatic, no width changes are required.
button to activate voltage reading. Measurement
button to activate resistance reading. Measurement
Using this button, you can read
the time values. Two bars are
displayed. Click and drag the
bars to the desired position
Using this button you can read
width for the 4 channels. A bar
is displayed. Click and drag it to
the position to be measured.
Disables measurements and
displayed bars