SICK HTE18 Manual De Instrucciones página 43

1.8 Commissioning
1.8.1 Alignment
1.8.2 Check the application conditions
8017851.1HW2/2022-11-14 | SICK
Subject to change without notice
-xxxxxD
-xxxxxG
Q1 = D.ON
-xxxxxK 1
Adjusta‐
-xxxxxN
ble OFF
Delay
-xxxxxK 2 Q1 = L.ON
1 L/D Selection Switch in in the "D" Dark Switching position
2 L/D Selection Switch in in the "L" Light Switching position
Sensor with red light:
Align sensor on object. Select the position so that the red emitted light beam hits the
center of the object. You must ensure that the optical opening (front screen) of the
sensor is completely clear [see
Sensor with infrared light (not visible):
Align sensor on object. Select the position so that the infrared light hits the center of
the object. The correct alignment can be detected via the signal strength light bar on
the back of the sensor and the LED on the top of the sensor. See
You must ensure that the optical opening (front screen) of the sensor is completely
clear.
Figure 6: Alignment
Sensing range
Check the application conditions: Adjust the sensing range and the remission capability
of the object according to the corresponding diagram [see
y = operating reserve).
During this process, an object can only be detected in front of a background if the
remission capability of the object is significantly higher than that of the background or if
the distance between the object and the background is sufficiently long.
OPERATING INSTRUCTION
figure 6].
O P E R A T I N G I N S T R U C T I O N | HTE18
figure 6 and table 12.
table 21]. (x = sensing range,
43