Publicidad
Idiomas disponibles
Idiomas disponibles
7.0 ASSEMBLING THE PRODUCT
7.1. General information
The myLEDmask device is delivered in one piece, already assembled.
Before using it for the first time, it is recommended that you fully charge the mask for
at least 3.5 hours using the charger. When the battery is fully charged, the indicator
light on the charger turns green, meaning you must unplug the charger. Let the mask
sit for one hour after each complete charging, and ensure it is unplugged before using.
The device must be unplugged when in use.
To connect the device to the power supply and turn it on, an IEC electrical outlet with two
terminals is all that is needed (see 4.2 Device components).
Device settings are adjusted ahead of delivery. There is therefore no need for any calibrations
by the user. However, it is important to follow the instructions in Chapter 8 – Using the
Product.
7.2. Attaching the strap
Introduce the strap into the
slotted tab on either side of
the mask.
7.3. Power supply
• Connecting your myLEDmask to the lower part of the neckpiece
32
User Manual Version No. 800866-EN01
Slide the strap into the
plastic loop.
To operate your myLEDmask, you will need to connect to a 100-
240V 50Hz electrical power supply.
The charger must not be used in a humid atmosphere or near a
source of water.
Connect the charger cord's jack plug to the lower part of the
neckpiece.
Adjust the strap so it
fits snugly around your
head.
Publicidad
