myBlend myLEDmask Manual De Instrucciones página 33

Check the state of charge of the LED mask.
When you plug in your LED mask, an indicator light shows the battery's state of charge.
Indicator light
Orange
Green
Note:
Unplug the mask when the green light appears, and let it sit for at least one hour before using.
Your fully charged myLEDmask can then be used for up to six sessions, with a 30-minute
pause between each session (see 4.3 Operating features). To accommodate regular use
thereafter, simply recharge the device as needed using the charger cord.
Once your myLEDmask is charged, you must remove the charger cord from the neck
piece before using the device.
The device must be unplugged when in use.
8.0 USING THE PRODUCT
STEP 2: Turn on your myLEDmask
Turn on your mask by pressing the "On" button
neckpiece.
• Plugging your myLEDmask into the electrical power supply
Plug the charger into an electrical outlet (100-240V 50Hz) using
the specific adaptor suited to your country (four different adaptors
are provided).
Let the mask charge for at least 3.5 hours, until it is fully charged.
Remove the charger cord from the neckpiece and from the electrical
outlet, and let the mask sit for at least one hour after each full charging.
State
Charging
Fully charged
No particular skills are needed to use the myLEDmask. It was
designed for easy use thanks to predefined programs, which
minimize the number of steps required.
STEP 1: Prepare your skin for the facial
Clean and dry your face before each session in order to
eliminate makeup and impurities.
(8.0 STEP 8 Clean your LED mask)
found on the control panel in the mask
User Manual Version No. 800866-EN01
myLEDmask
User Manual
33