Joie steadi Manual De Instrucciones página 11

While pressing the child restraint, pull the belts to fasten the child
restraint tightly and securely.
!
Please check by moving the child restraint back and forth.
!
Shoulder belt passes through Lock-off Device, confirm the Lock-off
Device is pushed down, as
!
The vehicle buckle tongue is engaged with the buckle correctly, as
iv. Securing your Child in the child restraint
see images
-
26 27
Note
1. When installing the child restraint in the forward facing mode, DO NOT
use the small seat pad.
2. Please install the child restraint on the vehicle seat, and then put the
child in the child restraint.
3. After the child is placed into the child restraint, check whether the
shoulder harnesses are at proper height.
1. Loosen the shoulder belts by activating the belt adjuster on the center
and simultaneously pulling both shoulder belts upwards.
2. Open the belt buckle by pressing firmly on the red button.
child in the seat and put the shoulder belts over the child's shoulder.
3. Bring both belt tongues together and lock them into place in the belt
buckle with an audible "CLICK".
4. Pull down the adjustment webbing and adjust it to the proper length so
that your child is snugly secured.
!
Make sure the space between the child and the shoulder harness is
about the thickness of one hand.
Height Adjustment
for Head Support and Shoulder Harnesses
see images
28
1. Please adjust the head support and shoulder harnesses to proper
height according to the child's height.
2. Squeeze the head support adjustment lever
pull up or push down the head support until it snaps into one of the 6
positions. The head support positions are shown as
9
24
23
12
-1. place the
10
11
27
-1, meanwhile
28
28
Cautions
!
After removing the foam of small seat pad, please store it somewhere that
the child can not access it.
!
Please wash the soft goods with cold water under 30°C.
22
!
Do not iron the soft goods.
!
Do not bleach or dry clean the soft goods.
!
Do not use undiluted neutral detergent, gasoline or other organic solvent to
wash the child restraint. It may cause damage to the child restraint.
!
Do not twist the soft goods to dry with great force. It may leave the soft
goods with wrinkles.
!
Please hang dry the soft goods in the shade.
!
Please remove the child restraint from the vehicle seat if not in use for a
long period of time. Put the child restraint in the shade and somewhere your
child can not access it.
Soft Goods Assembly
see images
26
1. Place the seat pad on the body and thread the buckle through the seat pad
slot.
29
2. Wrap the buckle with the elastic on the inside of the crotch strap.
3. Thread the adjustment webbing and harnesses on both sides through the
seat pad respectively.
4. Place the fastening pieces in top of seat pad into the two slots on the head
of the body.
5. Place the fastening pieces on sides of the seat pad into the four slots on
both sides of the body.
6. Assemble 2 pairs of elastic straps on both sides of head support.
7. Put the small seat pad into the child restraint and engage the buckle.
The assembled soft goods are shown as
-
29
34
-1
30
31
32
34
30
33
12
10