Charging The Battery; Programmer Power Up - Axium MN20600-02 Manual Del Usuario

Charging the Battery

The Programmer System comes with a Charger. The Programmer must be fully charged before using
it for the first time. It takes approximately two to four hours to fully charge the battery. The Programmer
Status Bar at the bottom of the screen shows the battery charge level.
1. Plug the Charger into a power outlet.
2. Connect the Charger to your Programmer.
When the battery is charging, the battery icon on the screen
shows "AC". When charging is complete, the amber light
becomes green.
Your Programmer will operate when it is connected to a power outlet. It
does not use battery power when connected to an outlet. Connect your
Programmer to the Charger and plug it in to an outlet regularly to keep
it charged. Do not leave Charger plugged into a power outlet overnight.
NOTE: Use only the Model MN23400-U Charger. It was included with your Programmer. Use of
any other charger could damage your Programmer.
The battery can be expected to last at least 500 discharge
cycles with normal use. Once it fails to hold a charge, it
should be replaced by Spinal Modulation personnel only.
Do not attempt to change the battery. Your Programmer
and Charger can be expected to last up to two years with
normal use.

Programmer Power Up

Press the " " button to turn ON your Programmer screen.
The Main Menu will display.
NOTE: If your Programmer does not turn ON, charge the battery and try again.
The device is
charging when
the amber light
is on.
8
Press here
to turn on
Programmer
screen.