Stimulator Binding; Connect; Magnet; Connecting With Your Stimulator - Axium MN20600-02 Manual Del Usuario

Stimulator Binding

Your doctor will bind and unbind your Stimulator to your Programmer. You cannot edit this information.

Connect

Use the "Connect" button on the Main Menu to connect with your Stimulator and to adjust your Stimulator
settings. See the "Connecting with Your Stimulator" section below.

Magnet

A magnet is located under the magnet symbol on the back side
of the Programmer. Place the magnet over the Stimulator to
check for connection between the Programmer and Stimulator.
See the "Connecting with Your Stimulator" section below for
more detail.

Connecting with Your Stimulator

Use your Programmer to communicate with your Stimulator.
• Turn ON your Programmer. The Main Menu will display. Your Programmer must be within three feet
of your Stimulator.
• Press the "Connect" button. The Programmer will begin searching for the Stimulator. An icon shows
on the screen to show that it is busy.
• Hold the magnet on the Programmer over your Stimulator and move it around in a circular
motion to start communication.
• The Programmer chimes when it is connected to your Stimulator. The Pain Control screen will then
display. "Connected" shows in the status bar at the bottom left of the screen. If your Programmer
cannot connect to your Stimulator, an error message displays. "Disconnected" shows in the status
bar.
• If your Programmer cannot connect to your Stimulator, go back to the Main Menu. Press
"Connect" again. Move the magnet in a circular fashion over your Stimulator. Repeat until the
Programmer connects to the Stimulator.
NOTE: If after two minutes your Programmer cannot connect to the Stimulator, place the
Programmer over the Stimulator again. An error message may display. The message asks you
to confirm that your Programmer is near enough to the Stimulator. After confirming that your
Programmer is within three feet of the Stimulator, press "OK". Press "Connect" again.
10
Magnet Location