Publicidad
Idiomas disponibles
Idiomas disponibles
30
12.3 TBA130 Handlebar throttle 36V – TIBODA; TBA131 Handlebar throttle 48V
The TIBODA also has a handlebar throttle.
This accessory can be retrofit to the drive, to do so proceed as indicated below.
12.3.1 Installation
Fig.28
A
4. Open the cable compartment by undoing the 3 screws and route the throttle cable through the
hole at the top of the compartment (Fig. 28)
5. Connect the 5 pin socket (Fig.29) in the TIBODA cable compartment.
Close the compartment
13. CLEANING AND DISINFECTION
Use a damp cloth and non-abrasive neutral detergent to clean the device's plastic and metal parts.
Do not use products which can scratch the product.
WARNING!
•
DO NOT immerse the device in water for any reason!
•
Sea water and sand can damage parts of the "Tiboda" if they remain in contact with
it for a long time. Always clean the "Tiboda"after using it at the seaside
•
Never use acid, alkali or solvents (acetone or diluent) to clean it
NOTES: For more thorough disinfection, use a small amount of neutral detergent and dry it off very
carefully, making sure that no fluid enters the product
•
If necessary, clean the product with an approved disinfectant. Make sure the disinfectant is safe
for the product before you use it
•
Read the disinfectant's and detergent's safety instructions before using them. Failure to do so
may result in irritation of the skin and damage to the device's controls and finish
Fig.27
B
C
1. Fit the handle throttle on the handlebar as
shown in figure (Fig.27)
2. If the lever throttle is already present,
disconnect and remove it.
a) Now remove the handle using a
compressed air gun to blow into the hole
on the side of the handle itself. Remove
the other handle too if necessary
b) Undo the grubscrew on the throttle
mount and remove the throttle
3. Fit the throttle handle to the handlebar and
secure it with the grubscrew
Fig.29
Publicidad
